Pathfinder45
New member
Is there anyone that still makes a lower profile safety for the Winchester model 54? Is there a conversion to a model 70-type safety, that would be more scope-friendly?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Winchester model 54 safety conversion
- Thread starter Pathfinder45
- Start date
I seriously doubt anyone would make a safety conversion for a rifle that was last produced 70 years ago. I don't know if a Model 70 bolt shroud would fit, but I can take a look tomorrow and post on here. You could probably modify a M98 safety conversion if you were determined to go that route.
Last edited:
Pathfinder45
New member
Thanks Scorch. And then there were these: http://edlapourgunsmithing.com/3-position-safeties/winchester-m5470/
....but I don't think they are making them anymore. It's for my brother's model 54 Carbine. If it were up to me, I would just put a receiver sight on it and call it good.
....but I don't think they are making them anymore. It's for my brother's model 54 Carbine. If it were up to me, I would just put a receiver sight on it and call it good.