VLD Deburring Tool

[cdbeagle]

Will they work to deburr case necks for use with non VLD bullets? I figure they can, just want to make sure. Here is an example:

http://www.cabelas.com/product/RCBS...Ntt=RCBS+VLD&WTz_l=Header;Search-All+Products

 

[Bart B.]

That tool's got the same angle as Easy Outs I've used to deburr case mouths. While Easy Outs don't have a sharp cutting edge, they roll and fold over the inside feathered edge of case mouths after they're trimmed. I've used Easy Outs for decades.

Get the size that lets about half of the spiraled section go into the case mouth. Turn it clock wise to deburr the edge. Then put a bore brush in an electric drill and use that to clean the case mouth as well as put a final finish on the inside edge.

Best thing I've used on case mouth. No more scratched bullets and they seat very easy.

 

[rg1]

Yes the VLD works well for deburring for all bullets. Careful though as it'll cut more than the standard tool and you can overdo it and get sharp thin case mouths. May not work on short pistol cases because of the long tapered profile. You need both the VLD and a standard deburr tool.

 

[cdbeagle]

Thanks