I notice some interest about Hi-Powers on this board.
I would like to get my old Inglis HP set up
for IDPA/carry.
It's currently at the 'smith getting a fiber
optic front sight and a wider rear notch.
I have removed the mag disconnector
to lighten the trigger-( I know about the
potential liability problems).
The problem is, the trigger pull is still at
nine to ten pounds. The gunsmith I use is
a master with the 1911. He professes no
knowledge with the Browning.
Should I learn to live with the heavier pull?
Or, is an Inglis made HP worth the expense
as a base gun to have further smithing done?
I would like to get my old Inglis HP set up
for IDPA/carry.
It's currently at the 'smith getting a fiber
optic front sight and a wider rear notch.
I have removed the mag disconnector
to lighten the trigger-( I know about the
potential liability problems).
The problem is, the trigger pull is still at
nine to ten pounds. The gunsmith I use is
a master with the 1911. He professes no
knowledge with the Browning.
Should I learn to live with the heavier pull?
Or, is an Inglis made HP worth the expense
as a base gun to have further smithing done?