Some load data for .325 WSM

[onlybrowning]

I was searching for some good data for a while with no luck, so I went it alone. I have my Browning A bolt Stainless Stalker shooting sub MOA with 65.5 grains of H-4350 and almost as good at 65.0gr. I also tried H-4831sc and it grouped well with the max charge of 65.8 but not so well with less powder. All shots fired using a Nosler Ballistic Tip 180 grain bullet, Winchester (new-not fire formed) brass and Federal 215M primers.

 

[Scorch]

I was searching for some good data for a while with no luck, so I went it alone

also tried H-4831sc and it grouped well with the max charge of 65.8

How do you know what the max charge is if you couldn't find any reloading data? Did you look at a Hodgdon reloading manual go to www.hodgdon.com ? Your loads are exactly at their published max loads. Did you look at a Lyman reloading manual? Just wondering how much research you did prior to experimenting.

 

[onlybrowning]

No I used a reloading data manual for the data, I meant that nobody offered any leads to what worked for them.

 

[Scorch]

Just seemed kind of funny that your loads were at Hodgdon's listed max. Anyway, I have always liked the Lyman reloading manual because they tell you which loads were the most accurate tested. Take a look at one, you may like it too.