Smoothing a rough extractor

A

AL45

New member
The extractor on my Carcano bolt is marring the rim on the brass. It ejects the case fine, but there are marks on all the rims and all the area that engages the rim looks rough. How is the best way to smooth these tight areas up? I was thinking of a thin Dremel buffing wheel and jeweler's rouge or a thin smooth stone. Any ideas?
 
M

mete

New member
Use a stone ! Dremels usually do things like round edges .Stones give better control and better edges.
 
O

Old Stony

New member
Any appropriate abrasive rubber wheels on your dremel will probably provide the smoothing you want without removing too much material. Sometimes it's tough to find the right comprimise between a buffing wheel and a stone, but cratex might do the job for you.
 
G

g.willikers

New member
Another vote for using a mild abrasive rubber wheel or cone, with the dremel.
But with a very light touch, and slow speed.
The problem, at least around here, is finding the wheels.
Lots of dremel accessories are available, except those.
 
D

Dixie Gunsmithing

Moderator Emeritus
I always use stones and needle files to shape these. Use a magnifying glass or lamp, to get a good look, and a small vise to hold it while you work on it.
 
W

Wreck-n-Crew

New member
I always use stones and needle files to shape these. Use a magnifying glass or lamp, to get a good look, and a small vise to hold it while you work on it.
Click to expand...

Good advice^^^

Getting a good eye on what you are doing and using a needle file and light stone to polish if necessary as well. A vise make it much easier to work by keeping the part good and steady.

I am not saying you can't be successful with a dremel and the right abrasive attachment, but it is too easy to make a mistake with one a needle file has a good shape to begin with for your project.

Slow and easy gets my vote!
 
J

James K

Member In Memoriam
On the PPK, it is tricky, but yes. And you want to crawl under a sheet to do it, else things fly away and get lost. Hold the slide in a vise, and use a small screwdriver to push the extractor spring plunger back into the slide. Then use small pliers to pull the extractor out. To replace the extractor, put the spring and plunger in (watch which way the plunger goes). Then use the extractor itself to push the plunger back until the extractor tail snaps into the hole and the plunger snaps over the extractor.

If you mess up and spend two hours on the floor in the corner, don't blame me; I told you to use that sheet!

Jim
 
You must log in or register to reply here.
Top