Recently acquired a 1944 Smith Corona. Barrel is marked 7-43. Figured to load it like I load for the M1 Garand since I figure that is what was used at the time. Plus the gun is almost 80 years old. Only planning to shoot at the range for now. Eyes have only worsened with age. Anyway any ideas on handloading. I am planning to use Lapua 30 06 brass. Have used it in M1 and it has really made a difference. Also planning to use 168 grain Sierra hpbt bullets. Any suggestions?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Smith Corona 1903A3
- Thread starter Linker
- Start date
mikejonestkd
New member
I have a 1944 Remington 1903A3, and load it with data that I use for my Garand. Enjoy, its a nifty rifle.
A lot depends on the condition of the barrel. If the rifle has a good crown boat tail bullets will shoot great but I have found, shooting a lot of milsurps, that for short range, being anything under 300 yds, a 150gr flat base bullet is the best. That's using any of the big name flat base hunting bullets with 48-49gr of imr4895. Plus they cost less also imr4064 will also work great. That's been my experience your mileage may vary.
Last edited:
I have both a Garand and a 1903A4 replica.
You get to decide if you want to keep track of two different 30-06 loadings.
I can get great performance with 168 gr bullets and IMR4350 through my 1903A4gery but I will not shoot those in my Garand.
To keep life simpler, The Garand loads,whatever I use,will shoot fine in the bolt rifle.
So,for myself, its H-4895 and a 155 or 168 that will work in either rifle.
Bolt gun only, I prefer IMR4350 and 168 or 175 gr bullets. But I keep those away from the Garand.
You get to decide how you want to do things
You get to decide if you want to keep track of two different 30-06 loadings.
I can get great performance with 168 gr bullets and IMR4350 through my 1903A4gery but I will not shoot those in my Garand.
To keep life simpler, The Garand loads,whatever I use,will shoot fine in the bolt rifle.
So,for myself, its H-4895 and a 155 or 168 that will work in either rifle.
Bolt gun only, I prefer IMR4350 and 168 or 175 gr bullets. But I keep those away from the Garand.
You get to decide how you want to do things
The NRA approved load for the Garand used to be 47gr IMR 4895 with the 168gr bullet. My favorite A3 shoots less than 1/2” @ 100yds with that load. A lot of people complain about the 4895 and insist there are a number of better powders for that use but when it puts them in the same hole I’m sticking with it.