I have mounted a Delta point to my sig. P210a target using the EGW mount.
I'm having a little problem with the Delta point I'm going to need to send it in for repair.. It drifts.
In the meantime I have a sig. Romeo one Pro that has the same footprint as the Delta point and will fit on the EGW mount.
The difference is there are no guide holes on the sig Romeo one Pro, the bottom is flat.
In order to mount the scope have to grind down the two alignment post on the EGW mount to make a flat surface.
The only thing holding the red dot in place will be the two mounting screws.
Sig says this is fine it should hold..
I don't know if I agree with that I, was thinking of using a drop of RTV or a small piece of double-sided tape very thin to hold it from ever moving.
Any comments would be appreciated.
I'm having a little problem with the Delta point I'm going to need to send it in for repair.. It drifts.
In the meantime I have a sig. Romeo one Pro that has the same footprint as the Delta point and will fit on the EGW mount.
The difference is there are no guide holes on the sig Romeo one Pro, the bottom is flat.
In order to mount the scope have to grind down the two alignment post on the EGW mount to make a flat surface.
The only thing holding the red dot in place will be the two mounting screws.
Sig says this is fine it should hold..
I don't know if I agree with that I, was thinking of using a drop of RTV or a small piece of double-sided tape very thin to hold it from ever moving.
Any comments would be appreciated.