I have a mossberg 835 and the length of pull is a little too long. Shooting 3in mag turkey loads is not a problem but when I step up to 3.5 i can really notice it. I want to shorten the stock by about and inch. If I shorten the stock rather than attaching the recoil pad back to it could I just put a slip on recoil pad or would the edges of the stock be to sharp?
Mossberg 835 Stock
- Thread starter OldSoul
- Start date
Sounds like a good idea for me. Now I have another question. Are there any parts of the gun that should not be painted. I'd like to take the redneck a step farther. This of course is a gun of function not a safe queen. The barrel has scratches and the matte black is scratched and I want to protect it from rust. Thinking a nice camo pattern would do wonders.
I would fully strip it down... tape in the safety tab indent as paint cannot lead to a smooth Mossberg safety...
From the inside, tape off the trigger group opening and ejection port leaving just the mag access port and barrel hole to be filled with tissue to keep paint out of the receiver where it could also bugger up in the action etc...
Screwing your stock bolt back in gives a good place to hold it while painting as well as fills that hole too...
As for barrel, you will see the close tolerance areas on the mating surfaces that go in the gun...
Brent
From the inside, tape off the trigger group opening and ejection port leaving just the mag access port and barrel hole to be filled with tissue to keep paint out of the receiver where it could also bugger up in the action etc...
Screwing your stock bolt back in gives a good place to hold it while painting as well as fills that hole too...
As for barrel, you will see the close tolerance areas on the mating surfaces that go in the gun...
Brent
To shorten the stock you can also get a reduced LOP Mossy 500 stock and drop it on. 500 and 835's are interchangeable there. Even if you currently have the Viking Green stock it won't matter much if you're going to paint it anyway.
Besides, shortening the plastic stock is more of a pain than doing the wood ones....BTDT.
Besides, shortening the plastic stock is more of a pain than doing the wood ones....BTDT.