assuming your magazine is long enough to handle long cartridges (remember to check this at home, and not find out in the field), i like to neck size a piece of brass, seat the bullet real long, and force it to chamber. then i put this cartridge into the bullet seater, screw the stem down a half turn at a time and repeat until i get no rifling marks on the bullet. i make up another dummy and seat it to the new setting to be sure there are no marks. if there isn't, i mark this cartridge w/ a sharpie, labeling all the bullet data. next time i make up loads for this combination, i just adjust the seating die to fit the dummy, and then i'm done.
the initial process can be somewhat time consuming, but once you get the dummy made up, it is easy from then on out. before you crank out a few hundred rounds, make sure to test feeding and extraction. if 10 or 15 random rounds feed and extract ok, you are set.
if you are using flat base bullets, seat a bullet long backwards, force it into the chamber, and it should only take a half turn or so more on the seating die to get it adjusted right. assemble a dummy w/ the bullet seated the right way, check it, and you should be done. again, check function.