Magnetospeed Unplugged Bayonet Error

[USAF Ret]

So, I was at the range today. All things going well and good. Set my rifle to the side for the barrel to cool, pick it back up and get an error that the bayonet is unplugged, when it was plugged in and working fine 10 min before.

Anyone run into this before?

 

[jetinteriorguy]

I’ve never had this, perhaps a new battery is in order.

 

[USAF Ret]

I’ve never had this, perhaps a new battery is in order.

Tried the battery. Feedback I have gotten is this is a common problem with the older models. I got mine from Amazon, so it very well could be backstock. Got a message out to customer service. It is still under warranty, so hopefully they will replace it.

 

[USAF Ret]

Great customer service. They are sending a new one with a label to send the old one back.

 

[higgite]

I'm late to the party, but I agree their customer service is top notch. I had a connection issue with my V3 6 years ago and they replaced the whole kit for no charge and have sent me some replacement spacers and screws for my pic rail adapter for no charge.

 

[USAF Ret]

I'm late to the party, but I agree their customer service is top notch. I had a connection issue with my V3 6 years ago and they replaced the whole kit for no charge and have sent me some replacement spacers and screws for my pic rail adapter for no charge.

Sounds like they had a small period a few years ago when CS was not great, but I can't complain at all. Just wish I had the V3.