Was reloading last night so as to sight in a new scope.
Using Hornady Interlocks, they were cheap.
Pulled casing from press to place in my container, and noticed something was off.
Namely the bullet.
Was stuck in the seating die.
Checked die, cleaned with some mild steel wool, and used a touch of spray silicone to lube a bit.
Next bullet stuck also.
Checked bullet diameter, (just to make sure). Was right on the money.
Pulled a Speer bullet from stock. Went right in, no problems.
Tried a Nosler BT. Again no problems.
Tried the Interlock again. Stuck...
Anyone else run into this?
Using Hornady Interlocks, they were cheap.
Pulled casing from press to place in my container, and noticed something was off.
Namely the bullet.
Was stuck in the seating die.
Checked die, cleaned with some mild steel wool, and used a touch of spray silicone to lube a bit.
Next bullet stuck also.
Checked bullet diameter, (just to make sure). Was right on the money.
Pulled a Speer bullet from stock. Went right in, no problems.
Tried a Nosler BT. Again no problems.
Tried the Interlock again. Stuck...
Anyone else run into this?