I'm reloading 7mm-08.
Using the Lee reloading information, along with references from Hogdon's manual.
139 gr. Hornady SST
Casings chamfered, deburred, trimmed. Primer pockets cleaned.
43.5 gr. of Hogdon H414
Bullet seated 0.010" off of the lands for my rifle.
I do collet sizing, not full length.
Getting hard extraction.
Flattened primers.
Casings shiny from being pressed into bolt head.
Obviously not reusing those casing again!!!
Pulling bullets out and dumping powder.
Checking weight.
43.5gr.
Any ideas???
Or rather does anybody want some H414? I'm planning on going back to Alliant Reloader 17.
I would like to know why such a low charge would over pressure!!!
Std7mag
Using the Lee reloading information, along with references from Hogdon's manual.
139 gr. Hornady SST
Casings chamfered, deburred, trimmed. Primer pockets cleaned.
43.5 gr. of Hogdon H414
Bullet seated 0.010" off of the lands for my rifle.
I do collet sizing, not full length.
Getting hard extraction.
Flattened primers.
Casings shiny from being pressed into bolt head.
Obviously not reusing those casing again!!!
Pulling bullets out and dumping powder.
Checking weight.
43.5gr.
Any ideas???
Or rather does anybody want some H414? I'm planning on going back to Alliant Reloader 17.
I would like to know why such a low charge would over pressure!!!
Std7mag
Last edited: