You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
High Standard Victor ejector broke..
- Thread starter SIGSHR
- Start date
Start here. http://stevespages.com/ipb-histandard-victor.html
You'll note there is no ejector on the parts list. I believe the extractor ejects too.
On this page is the manual for an M107. That is the Victor. Don't think it's going to help much, but it can't hurt. http://stevespages.com/page7b.htm
Gunparts wants $9.90 for a new extractor. I think I'd change the plunger and its spring too. $5.40 for the former. $3 for the spring.
You'll note there is no ejector on the parts list. I believe the extractor ejects too.
On this page is the manual for an M107. That is the Victor. Don't think it's going to help much, but it can't hurt. http://stevespages.com/page7b.htm
Gunparts wants $9.90 for a new extractor. I think I'd change the plunger and its spring too. $5.40 for the former. $3 for the spring.
Extractor
The extractor pulls the fired case from the chamber as it is blown back and holds it against the bolt face as the bolt travels rearward. As it reaches maximum travel, the rim of the case strikes the tip of he ejector, on the frame at the left rear of the magazine well, and is kicked out out the open "port" at about the same time that the bolt has picked up a new cartridge.
The extractor pulls the fired case from the chamber as it is blown back and holds it against the bolt face as the bolt travels rearward. As it reaches maximum travel, the rim of the case strikes the tip of he ejector, on the frame at the left rear of the magazine well, and is kicked out out the open "port" at about the same time that the bolt has picked up a new cartridge.
Last edited: