I saw a nice 6" stainless Dan Wesson, made in Palmer, at a local shop.
I have a Monson 715. The barrel nut slots are obvious on the front of the barrel - you insert the DW tool in the front of the barrel, put the tool into the slots, unscrew the barrel nut, and take the barrel out of the shroud and off the frame.
On the Palmer gun, there were no slots on the front of the barrel assembly. I could not see a barrel nut.
No one at the shop could tell me how to take the barrel assembly off, nor did they have a tool. I could see no gap between the barrel and shroud, so i don't think the barrel nut is missing.
How do you change barrels on Palmer guns?
I have a Monson 715. The barrel nut slots are obvious on the front of the barrel - you insert the DW tool in the front of the barrel, put the tool into the slots, unscrew the barrel nut, and take the barrel out of the shroud and off the frame.
On the Palmer gun, there were no slots on the front of the barrel assembly. I could not see a barrel nut.
No one at the shop could tell me how to take the barrel assembly off, nor did they have a tool. I could see no gap between the barrel and shroud, so i don't think the barrel nut is missing.
How do you change barrels on Palmer guns?