I bought a new CZ 75B Satin Nickel last week and I was not able to take it down to clean it because I was out of town. Anyway I took the slide off and noticed that some of the Nickel plating was bubbling/flaking off on one side of the slide. I just sent in the warranty card yesterday and already may need to use it??
I am not sure if I am nitpicking as this area is not normally seen and will more then likely ware over time but, I wanted to know what you guys would do if you were in my shoes?
Has anyone else had these issues and was it relatively painless to send it back to CZ to be fix?
Below are pictures of the affected area.
I am not sure if I am nitpicking as this area is not normally seen and will more then likely ware over time but, I wanted to know what you guys would do if you were in my shoes?
Has anyone else had these issues and was it relatively painless to send it back to CZ to be fix?
Below are pictures of the affected area.