You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Any thoughts on the cause of excessive pressure in this .327 Federal Magnum?
- Thread starter Carmady
- Start date
Aguila Blanca
Staff
How can the same ammunition, from the same box, be over pressure (creating flattened primers and stuck cases) in a revolver and not be over pressure in a rifle?
Logical fail. I stopped watching at 5:05. Couldn't take any more.
Logical fail. I stopped watching at 5:05. Couldn't take any more.
How can the same ammunition, from the same box, be over pressure (creating flattened primers and stuck cases) in a revolver and not be over pressure in a rifle?
Logical fail. I stopped watching at 5:05. Couldn't take any more.
You don't seem to understand very much about guns.
stinkeypete
New member
Waste of a video.
Contact Ruger Customer Service, explain issues. They will make it right.
Flattened primers is not an indication of pressure other than .327 is a high pressure cartridge. This is various boxes of factory ammunition. It’s not the ammo and what it’s shot in doesn’t change the pressure unless the bullet is touching the forcing cone or more.
Difficult extraction might be overpressure. It might be chambers out of spec too large, too small, chambers rough, or bad brass.
Shooting low...file some metal off the front sight, slow and careful... Or send it to Ruger!
Send it.
Contact Ruger Customer Service, explain issues. They will make it right.
Flattened primers is not an indication of pressure other than .327 is a high pressure cartridge. This is various boxes of factory ammunition. It’s not the ammo and what it’s shot in doesn’t change the pressure unless the bullet is touching the forcing cone or more.
Difficult extraction might be overpressure. It might be chambers out of spec too large, too small, chambers rough, or bad brass.
Shooting low...file some metal off the front sight, slow and careful... Or send it to Ruger!
Send it.
Last edited:
Aguila Blanca
Staff
No, I guess not.74A95 said:You don't seem to understand very much about guns.
Here's another video by another person with the same brand of revolver with similar accuracy (shooting low) issues, plus keyholing. No mention of flattened primers or stuck casings. Disregard the "38 S&W Long" part.
https://www.youtube.com/watch?v=yvmITZqi0kM
https://www.youtube.com/watch?v=yvmITZqi0kM