Magnum Wheel Man
New member
so I went to load some of my 1st 45 BPM loads last night... I purchased a Lee die set for 460 S&W, my cases are 460 S&W with the head stamps knurled off, & rolled flat... I like to use a Lee hand prime to prime my cases, & found the shell holder I use for 45 Colt won't fit my Hornady 460 cases... I thought the 45 Colt, 454 Casull, & 460 S&W all used the same shell holder... when I go to Midway, to look, I see the Redding shell holder states 45 Colt 454 Casull, & 460 S&W, but Lee had a different shell holder number for the 460 dies I bought, than what I use for the 454 Casull, or 45 Colt...
there must be slight differences in rim thickness or diameter ???
I think I was trying to use a #11 that is listed as 45 Colt... & I think I ended up using a #13 ( I had in my set I think it is listed as 45 Autorim ) anyway, the cut was too thick, resulting in the primers not seating flush... it worked, but required me to use my primer pocket swage tool to gently fully seat the 1st handful of primers... anyone hand prime 460 S&W... ( with a lee tool ) & can you tell me which shell holder works for you ???
thoughts...
there must be slight differences in rim thickness or diameter ???
I think I was trying to use a #11 that is listed as 45 Colt... & I think I ended up using a #13 ( I had in my set I think it is listed as 45 Autorim ) anyway, the cut was too thick, resulting in the primers not seating flush... it worked, but required me to use my primer pocket swage tool to gently fully seat the 1st handful of primers... anyone hand prime 460 S&W... ( with a lee tool ) & can you tell me which shell holder works for you ???
thoughts...
Last edited: