Search results

Hi, I am trying to identify a tool or something I got when I bought out a gunsmith The large outer ring in 1 X 1 inch and has tick marks on the right side where it tapers. It is .694 ID and 40 TPI the whole length. The inner barrel is .7135 OD and again 40 TPI. It is 1.13 long and has...

I know they are "lubricated for life" and I should not be considering it, but I have a Weaver V-4.5 (1.5 to 4.5 variable) that the power ring is very difficult to turn. Iron Sight Inc will be happy to overhaul it for $85.00, but I can replace the scope for less than that. It lives on a...

What is the correct headspace for a S&W 610 in 10mm (full moon clips)? Regular headspace gages (0.064 - 0.068) fall through and I get 0.102 with a gage pin. With fired cases in the chambers and moon clips, I get 0.004. The current barrel cylinder gap is 0.008.

Hi, I had two Hi-Powers apart yesterday at the same time and noticed that one had one had a ball detent at both ends of the spring guide and the the other only had one in the hole where the slide stop pin goes through. The one on the end where the slide stop pin goes, goes into a detent on the...

I am doing a trigger job on a Tarus 941 in .22 mag. The original double action pull was over 16 pounds and the single action pull over 6.5 pounds. I called Tarus and they said that the heavy pull was necessary for reliable function. :eek: I did some internal polishing and cut 2.5 coils off both...