Search results

I use a Wilson case trimmer for trimming. You have 2 different case holders, a case holder for new cases and a holder for fired cases. I understand that the new cases are slightly smaller than the fired cases. My question is when FL size the fired case doesn’t it go back to the original new size...

is the .380 cartridge the same size as 9mm except for the length ? Thanks

I have been reloading 300 Winchester Magnum with Norma brass and Barnes TTSX BT bullets. I have one case that I charged and seated a bullet but forgot to prime the case. I pulled the bullet and primed the case and recharged and seated the bullet. When I seated the bullet it went in with alot...

Do any of you guys have any experience using a Arbor press for hand reloading ?

Im looking to get a new hand priming tool. The 2 im interested in are the Sinclair hand priming tool and the 21st Century hand priming tool. Do any of you guys have knowledge of these or own on what is your opinion ? Thanks for the help.

I have been loading 264 Win Mag. Tonite when I went to prime some cases I noticed that I may have loaded some with Winchester WLP Large pistol for standard or Magnum loads instead of Large rifle for Magnum rifle loads. Would this be big problem ? Thanks for the help

Thanks everyone for your expertise and help. I decided to size my new Winchester 270 brass. After sizing I checked the length and they were between 2.530 and 2.535. Would it be worth the time to trim them all to 2.530 ? Again still learning a lot and appreciate the help.

I have brand new Winchester 270 cal brass, I always size it but am I waisting time, does the new stuff need to be sized ? what do you guys think, thanks

I just received some new Norma brass for 264 Win Mag. what do I have to do before charging and bullet seating ? book says trim to length 2.490 and they measure anywhere from 2.493 to 2.499. The blueprint demensions of the cartridge shows it to be 2.500. Any help would be appreciated. Thanks

I would like some opinions on sizing cases. I wonder how many use bump gages when setting up their sizing rifle dies ? I usually size the entire case but I have got a few Sinclair INtl. bump gages to move the shoulder back a few thousands. How do you guys feel about this or is it worth it. Just...

Had a friend ask me if Norma was a good brand of brass. What do you guys think the best kinds of brass are ?

I load 44 magnum. sometime back I bought a bag of 44 brass. Just a few days ago I was checking my brass and on this bag it says 44 Smith & Wesson while my others say 44 Remington magnum. Are these the same or is it a different cartridge ? Thanks

I have some 44 cal 240 grain no 4455 speer Handgun bullets to load. I am going to use 2400 powder. Does anyone have any load data for this bullet and powder . I have a speer book but its ancient. Thanks

Anyone reload for Henry Lever Action Big Boy 44 Cal.

anyone have a recipe for homemade solution for ultrasonic cleaner. need one for brass and gun parts. Thanks for the help

Im interested in getting a ultra sonic case cleaner. Anyone use these and have suggestions on which one would be the best ? Thanks for the help

Looking for a good decapping die...which one do you guys prefer ? Thanks

Do any of you use Headspace Gauges ? Which brand or kind would be good to get ? Thanks

Would like some advice, My reloading bench is in basement and I get water running across the floor especially in rainy season. I have powder and primer stored in cabinet top shelf. It is cool place but i"m thinking about moving primers and powder upstairs. Where do you guys store yours ? Thanks...

Trying to learn as much as I can. Powder burn rates, fast burning vs slower burning. does one work better with certain calibers. whats the general rule ? Thanks for the help