Search results

Does anyone have any good 44 spl. +P loads that are safe to shoot from a mdl.696 S&W with 3" bbl. I will be carrying it as a back-up for elk hunting in a couple of weeks. Prefer 200 or 240 gr jacketed if possible. Thanks

A couple of years ago the Portland Police Bureau had two issue Glock 45's blow up on the range. As a result, they changed back to Beretta 9mm's as dept issue. I never heard if they ever determined what caused the guns to blow up. Anyone have any updates?

Has anyone else heard that you are not supposed to shoot cast or swaged lead bullets in Glock barrels with the polygonal rifling. Supposedly they can build lead up at the leade and cause the gun to fire out of battery, which will result in a destroyed gun and possible injury to the shooter?

what's a good load for the Garand (147gr. fmj) to eliminate excessive pressures at the op-rod, but still reliably cycle the action?

Does anyone have any long-term experience with these conversions? They say they work fine, but I am wondering if they will eventually obstruct the gas port in the barrel with lead, and cause problems. Or problems with the direct impingement gas system itself? Any special cleaning procedures?

Does anyone know who made the 22lr SAA target-sighted revolvers for Mitchell Arms several years ago? Mine has a hammer block that is a lever on the hammer face that can be flipped off or on with the thumb. This is missing a spring I think that tensions the lever in position. It is a small coil...

Does anyone know anything about these revolvers? I have one that I believe was made for Mitchell Arms by Uberti a few years ago. My problem is the hammer block lever on the hammer face is meant to be flipped on or off by the thumb and is under spring pressure to hold it in either position. The...

I think I already know the advice on this one, but I gotta ask anyway. I have a russian M-44 that is really nice EXCEPT that I didn't discover until I went to the range that it has a counter-bored muzzle about 1.5 in down. I suppose this was to correct muzzle damage from improper cleaning.Is...

I have been told that it is unsafe to fire cast lead bullets thru the 1895G guide gun with the ported barrel because of lead shaving at the ports. Is this true? It is the 45-70 version. Any actual experience would be appreciated. Thanks

Does anyone know of an effective recoil pad changeover for this gun that is available? Prefer Sims, but do they make a pre-fit replacement? Love the gun, but the factory recoil pad has got to go!

Does anyone know what to do to change or modify the springs in a model 94 Taurus 22 l.r. revolver? Wolf does not recommend their small frame Taurus spring kit( Model 85 etc.) for this revolver.

has anyone else noticed that these high tech rust inhibitors like Sheath cause bluing to turn a reddish cast on some bluing. I'm pretty sure about my suspicions If so, doesn't the company have some liability here?

does anyone know how to replace the ejector spring in the cylinder of a ruger SRH? I know that the ejector retainer is not to be removed. Thnx