Finding reliable and accurate load data for your reloading projects is crucial for safety and optimal performance. This guide focuses specifically on Ramshot TAC powder and its application in .223 Remington ammunition. We'll explore various bullet weights, recommended starting loads, and crucial safety considerations. Remember, always consult your reloading manual and manufacturer's data sheets before undertaking any reloading project. This information is for educational purposes only and should not be considered a substitute for professional guidance.
Understanding Ramshot TAC
Ramshot TAC is a popular extruded powder known for its consistent burn rate and suitability for a wide range of applications. Its characteristics make it a good choice for .223 Remington loads, offering good accuracy and velocity. However, its performance can vary depending on the specific bullet weight and case capacity used.
Key Considerations Before Reloading
Before diving into specific load data, let's review essential safety precautions:
- Consult your manual: Always refer to your specific reloading manual and the manufacturer's data sheets for your chosen components. This is non-negotiable.
- Start low, go slow: Begin with the minimum recommended starting load from a reliable source. Gradually increase the charge weight in small increments, carefully observing pressure signs.
- Proper equipment: Ensure you have all necessary reloading equipment in good working order, including a scale capable of measuring powder charges to 0.1 grain accuracy.
- Cleanliness: Maintain a clean and organized workspace. Any contamination can lead to dangerous pressure spikes.
- Proper techniques: Learn and follow safe reloading techniques thoroughly. Improper handling of powder or primers can lead to serious injury or death.
- Observe pressure signs: Pay close attention to the cases after firing. Excessive pressure signs such as flattened primers, excessive case head expansion, or sticky extraction indicate you should reduce the powder charge immediately.
Ramshot TAC 223 Load Data (Sample Data – Consult Your Manual)
The following data is a sample and should not be used as a substitute for load data found in your reloading manuals. This data is presented for illustrative purposes only and might not be appropriate for your specific equipment or components.
Disclaimer: This data is for illustrative purposes only. Always consult your reloading manual and manufacturer's load data for the specific components you are using. Failure to do so could result in serious injury or death.
| Bullet Weight (grains) | Bullet Type | Primer | Case | Powder Charge (grains) | COL (inches) | Notes |
|---|---|---|---|---|---|---|
| 55 | FMJ | CCI #41 | Remington | 23.0 - 24.0 | 2.260 | Start low, work up |
| 62 | FMJ | CCI #41 | Remington | 22.0 - 23.0 | 2.260 | Start low, work up |
| 77 | FMJ | CCI #41 | Remington | 20.5 - 21.5 | 2.260 | Start low, work up |
Note: COL (Cartridge Overall Length) should be measured from the base of the cartridge case to the tip of the bullet. Always double-check your measurements to ensure proper chambering.
Factors Affecting Load Data
Several factors can influence the optimal load data for your .223 Remington ammunition:
- Bullet type: Different bullet designs (FMJ, JHP, SP) have varying ballistic coefficients and can affect pressure.
- Case brand: Variations in case capacity between manufacturers can also affect pressure.
- Powder lot: Powder lots can have slight variations in burn rate, requiring adjustments to the load data.
- Environmental conditions: Temperature and humidity can influence powder burn rate.
- Rifle characteristics: Your specific rifle's chamber dimensions and headspace can slightly affect pressure.
Conclusion
Reloading .223 Remington ammunition with Ramshot TAC powder can be rewarding, but it requires careful attention to detail and a commitment to safety. Always prioritize safe reloading practices, consult reliable load data, and meticulously track your results. Remember that the information provided here is for educational purposes only. Improper reloading techniques can lead to dangerous consequences. Always consult your reloading manuals and manufacturer's data sheets before starting any reloading project.
